Using The Remote Controller - Panasonic NV-EX21EG Operating Instructions Manual

1
1
2
3
15˚
1
15˚
15˚
15˚
START/
DATE/ PHOTO
STOP
OSD TIME SHOT
COUNTER RESET TITLE ZOOM
T
MULTI/
REC A.DUB
P-IN-P ¥
V /REW PLAY FF/ W
W
6 1 5
STILL ADV PAUSE STILL ADV
E ; D
INDEX STOP INDEX
2
K L
∫
SELECT
VAR. P.B.
SEARCH ZOOM
STORE
MENU
SET
OFF/ON
ITEM
P.B.DIGITAL
ª Inserting a Button-type Battery
Before using the Remote Controller, insert the supplied button-type battery.
1
While pressing the Stopper
2
Insert the button-type battery with the imprint (
upward.
3
Insert the Battery Holder into the Remote Controller.
≥When the button-type battery is exhausted, replace it with a new CR2025
battery. (A battery is normally expected to last about 1 year. However, it
depends on operation frequency.)
≥Make sure to match the poles correctly when inserting the battery.
.........................................................................................................................
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the equipment
manufacturer. Discard used batteries according to manufacturer's
instructions.
.........................................................................................................................
WARNING
Risk of fire, explosion and burns. Do not recharge, disassemble, heat
above 100xC or incinerate. Keep the Button-Type battery out of the
reach of children. Never put Button-Type battery in mouth. If swallowed
call your doctor.
.........................................................................................................................
~~~~~~~~~~~~~~~~~~~~~~~~~
ª Using the Remote Controller
1
Direct the Remote Controller to the Remote Control Sensor
of the Movie Camera and press an appropriate button.
≥Distance from the Movie Camera: Within approximately 5 metres
≥Angle: Within approximately 15o in the vertical and horizontal directions
from the central axis
≥The above operative ranges are for indoor use. Outdoors or under strong
light, the Movie Camera may not operate properly even within the above
ranges.
≥Within a 1-metre range, you can also use the Remote Controller on the side
(the LCD Monitor side) of the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used simultaneously, they can be operated
individually by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie Camera and that of the Remote
Controller do not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired
Remote Controller Mode. (l 13)
Setup on the Remote Controller:
[VCR1]: Press the [D] Button and [∫] Button simultaneously.
[VCR2]: Press the [E] Button and [∫] Button simultaneously.
≥When the battery in the Remote Controller is replaced, the mode is
1
automatically reset to [VCR1] Mode.
1
, pull out the Battery Holder.
i ) facing
1
2
9