Dmx Settings - QuickShow FB3-QS User Manual

30

DMX Settings

QuickShow may be setup to be controlled by an incoming DMX signal (DMX input), or to control
external DMX devices such as lights and fog machines (DMX output). Both of these are specified using
the DMX Settings dialog box, which is shown below.
First specify whether you want to use DMX Input or Output using the "Connection" portion of the
dialog box. After that, specify the COM port where the DMX-to-USB controller is connected.
QuickShow gives you the ability to test the connection of the USB device by pressing the Test
Connection button. If you have the proper COM port selected and the device is connected and working
properly, it should give you a message box which will show the serial number and firmware version
installed in the device as shown above.