QuickShow FB3-QS User Manual page 11

11
Step 2: Indicate the type of scanners you have
The second step in the process is to familiarize QuickShow with the type of scanners you have.
THIS IS VERY IMPORTANT! If you have low performance scanners and you tell QuickShow that
you really have high performance scanners, QuickShow may drive the scanners too hard, which may
cause excessive wear or heat. So when indicating the type of scanners you have, be as careful as
possible. The high performance setting is only for American-made scanners, as well as the most
expensive German and Chinese scanners.
Step 3: Indicate the number of lasers in your projector
The third step in the process is to familiarize QuickShow with the number of lasers in your projector.
This is important because if you only have a single-color laser and you tell QuickShow that you really
have an RGB laser, then certain colors will not be seen in the projected imagery. Note that QuickShow is
asking how many LASERS you have, not how many colors your projector can make (for example, a
two-laser projector can make at least three colors).