Self-Timer Recording (Vdr-D310/Vdr-D230); Recording Guideline Function - Panasonic DVD e.cam VDR VDR-D210 Operating Instructions Manual

Recording
≥ If it is difficult to focus, adjust the focus
manually. (l 61)
To cancel the MagicPix function
Select [ ] again.
≥ The MagicPix function makes the signal
charging time of CCD up to approximately 30k
longer than usual, so that dark scenes can be
recorded brightly. For this reason, bright dots
that are usually invisible may be seen, but this
is not a malfunction.
≥ If you turn off the power or operate the mode
dial, the MagicPix function is canceled.
≥ If set in a bright place, the screen may become
whitish for a while.
Self-timer recording
(VDR-D310/VDR-D230)
This is for recording shots of yourself
as well.
You can record still pictures on an SD card using
the timer.
¬ Rotate the mode dial to select
1
Press the joystick. Then move
the joystick down to display the
icon shown in the illustration.
2
Move the joystick left to select
[Ø].
3
Press the Photoshot button [
58
LSQT1145
(SD)
.
1/2 NEXT 1/2 1/2 NEXT NEXT
1/2 NEXT 1/2 1/2 NEXT NEXT
].
After the [Ø] display flashes for approx.
10 seconds, a still picture will be recorded.
≥ After recording, the self-timer is canceled.
≥ If you press the Photoshot button [
and then fully in auto focus mode, the subject
is focused when the button is pressed halfway.
(VDR-D310)
≥ When you press the Photoshot button [
fully in auto focus mode, the subject is focused
just before recording. (VDR-D310)
To stop the timer midway through
Press the MENU button. (The self-timer setting is
canceled.)
≥ If you turn off the power, the self-timer standby
mode is canceled.
≥ Depending on the time taken to bring the
subject into focus, the recording may take
longer than set to start.
Recording guideline
function
Checking if the image is level.
(RAM) (-RW‹VR›) (-RW‹V›) (-R) (SD)
You can check if the image is level while
recording by using the lines displayed on the
screen.
¬ Rotate the mode dial to select
.
Press the MENU button, then select
[BASIC] # [GUIDE LINES] # [ON]
and press the joystick.
] halfway
]
or
MENU