Remote Control (Optional); Wall Thermostat (Optional) - Masport P121-NG Owners & Installation Manual

INSTALLATION
Option 1:
REMOTE CONTROL
Use the Masport Remote Control Kit approved
for this unit. Use of other systems may void
your warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1) Choose a convenient location on the wall
to install the receiver and the receptacle
box (protection from extreme heat is very
important). Run wires from the fireplace to
that location. Use the Thermostat Wire
Table.
2) Connect the two wires to the gas valve.
See diagram below.
CAUTION
Do not connect millivolt remote
control wires to a 240V wire.
3) Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote"
mode. The remote control is now ready for
operation.
26
Option 2:
WALL THERMOSTAT
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use the table below to determine the maximum
wire length.
CAUTION
Do not connect millivolt
wall thermostat wires
to a 240V wire.
Refer to specific detailed instructions
supplied with each kit.
Masport P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA. 15.0 M.
16 GA. 10.0 M.
18 GA. 6.0 M.
20 GA. 3.6 M.
22 GA. 2.7 M.