Setting The Electronic Shutter; Shutter Modes; Setting The Shutter Mode And Speed - Panasonic AJ-HDC20A P Operating Instructions Manual

Camera/vtr
Table of Contents

Advertisement

Setting the electronic shutter

Shutter modes

Available shutter modes and shutter speeds
Mode
Shutter speed
Standard
1/100, 1/120, 1/250,
1/500, 1/1000 and
1/2000 (sec.)
SYNCHRO
30.3 Hz to 250.2 Hz
SCAN
range
SUPER V
<Notes>
O No matter in which mode the electronic shutter is
used, the higher the shutter speed, the lower the
camera's sensitivity.
O When the aperture is in the automatic mode, it will
increasingly open and the depth of focus will
become shallower as the shutter speed is
increased.
Setting the shutter mode and
speed
O The SHUTTER switch is used to set the shutter
speed and the shutter speed in the standard mode.
O The shutter speed in the SYNCHRO SCAN mode
can easily be changed using the SYNCHRO ("+"
and "–") buttons.
O On the SHUTTER SPEED screen of CAM MENU,
the setting range of the shutter speed can be
restricted to the required range and whether or not
to use the special operation modes (SYNCHRO
SCAN and SUPER V) can be selected.
Application
For shooting fast-moving
subjects clearly
For shooting in such a way
that the horizontal striping is
minimized on the monitor
screen
For increasing the vertical
resolution
52
1
Following the steps for "Switching the display
mode" (page 44), set DISP MODE to "2" or "3" on
the CAM VF DISPLAY screen of CAM MENU.
2
Press the SHUTTER switch from ON to SEL.
The current shutter setting appears on the setting
change message display area of the viewfinder
screen.
Example: "1/120," "1/61.2," etc.
SHUTTER switch
3
Press the SHUTTER switch to the SEL position
again, and repeat this until the desired mode or
speed is displayed.
When all the modes and speeds are displayed, the
display will change in the sequence shown below.
When the required shutter speed and mode have
been assigned beforehand, only the assigned
speed or mode will be displayed.
<Note>
When the unit is shipped, the SUPER V mode is
not assigned and so it will not be displayed.
Standard mode
1/100
1/120
1/250
SUPER V
mode
1/500
1/1000
1/2000
SYNCHRO SCAN
mode

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-hdc20Aj-hdc20apAj-hdc27aAj-hdc27apAj-hdc27vp

Table of Contents