Setting The Time Code - Panasonic AJ-HDC20A P Operating Instructions Manual

Setting the time data

Setting the time code

1
Set the DISPLAY switch to TC.
2
Set the TCG switch to SET.
3
Switch the TC MODE to DF or NDF on the TC/UB
screen of VTR MENU.
Select DF to run the time code in the drop frame
mode or select NDF to run the time code in the
non-drop frame mode.
4
Set the time code using the SHIFT button, "+"
button and "–" button.
SHIFT button:
This is used to start the digit to be set flashing.
Each time it is pressed, the flashing moves by
one digit to the right.
"+" button:
This increments by 1 the numerical value of the
flashing digit.
"–" button:
This decrements by 1 the numerical value of the
flashing digit.
5
Select the TCG switch position.
Select F-RUN for running the time code in the free-
run mode or select R-RUN for running it in the rec-
run mode.
Time code when the battery is replaced
The backup function works even when the battery is
replaced, and the time code generator continues to
operate for a prolonged duration (approx. 1 year).
<Note>
When the POWER switch is set to ON 5 OFF 5 ON,
the backup accuracy of the time code is approximately
±2 frames.
56
1
2,5
4