Shooting (Recording)/Playback Function Section - Panasonic AJ-HDC20A P Operating Instructions Manual

Parts and their functions
Shooting (recording)/playback
function section (1)
2
1
1 CC FILTER/ND FILTER (filter selector) control
This is used to select the filter to match the light
source which is illuminating the subject. If the
control setting is changed while the menu display
mode is set to "3" (default setting), the new setting
will appear at the setting change message display
area of the viewfinder screen.
$ Control settings and filter selection
CC FILTER control (large
diameter) setting
A
B
C
D
ND FILTER control (small
diameter) setting
1
2
3
4
O The two types shown above are provided for filter
combinations.
3
CC filter selection
Cross filter
3200 K
4300 K
6300 K
ND filter selection
CLEAR (Transparent)
1/4 ND
1/16 ND
1/64 ND
$ Examples of filter selection
Shooting conditions
Sunrise, sunset, inside a studio
Outdoors under a clear sky
Outdoors under cloudy or rainy
skies
Snowscapes, high mountains,
seashores or other perfectly clear
scenery
2 Synchro scan adjustment switches
These switches become effective when the shutter
switch 7 is set to ON and synchro scanning is
selected. They are used to adjust the synchro scan
speed.
When the "–" switch is pressed, the shutter speed is
reduced; conversely, when the "+" switch is pressed, it
is increased.
During personal computer monitor shooting, etc.
adjust these switches to the positions where the
horizontal bar noise inside the viewfinder is
decreased.
3 WHITE BAL (white balance memory selector)
switch
PRST : Set the switch to this position in cases where
there is not enough time to adjust the white
balance. The 3200 K white balance value is
stored in the memory. (This can be changed
to 4300 K.)
A or B : When the AUTO W/B BAL switch 6 is set to
AWB, the white balance is automatically
adjusted to match the setting position of the
CC FILTER control 1, and the adjustment
value is stored in memory A or memory B.
When the CC FILTER control and the WHITE BAL
switch are set to the same positions as they were
when adjustment was performed, the adjustment
value stored in the memory is recalled, and the unit
is automatically adjusted to the white balance that
corresponds to this value.
If this switch setting is changed while the menu
display mode is set to "3" (default setting), the new
setting will appear at the WHITE BAL switch display
position on the viewfinder screen.
(Example: "A")
13
CC filter ND filter
B 3200 K 1 (CLEAR)
C (4300 K) or 2 (1/4 ND) or
D (6300 K) 3 (1/16 ND)
D 6300 K 1 (CLEAR) or 2
(1/4 ND)
C (4300 K) or 3 (1/16 ND) or
D (6300 K) 4 (1/64 ND)