Grizzly G0771 Owner's Manual page 62

Setting 45° Stop
1.
DISCONNECT SAW FROM POWER!
2.
Raise blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted
any more.
3.
Place a 45° square against table and blade
so it contacts blade evenly from bottom to
top, as shown in Figure 114. Make sure a
blade tooth does not obstruct placement of
square.
45° Square
Figure 114. Checking blade at 45°.
—If blade is 45° to table, then no adjustments
need to be made. Proceed to Step 8.
—If blade is not 45° to table, you will need
to adjust 45° limiting block. Proceed to
Step 4.
4.
Remove rear access panel.
-60-
Blade
Table
5. Loosen (2) M5-.8 x 10 cap screws in 45° limit-
ing block (see Figure 115).
45° Limiting
Block
Figure 115. Location of 45° limiting block.
6.
Tilt blade away from 45° by about 5°, so there
is room for limiting block to move.
7.
Adjust 45° limiting block according to how far
off blade was from 45°, then recheck blade
and repeat adjustment as necessary until
blade stops at 45°, then tighten cap screws
and replace rear access panel.
8. Make sure tilt indicator arrow points to 45°
mark on scale. If it doesn't, adjust indicator
arrow as described on Page 59.
Model G0771 (Mfd. Since 8/15)
x 2