Grizzly G0771 Owner's Manual page 23

11. Install switch onto hex bolts from Step 6
using (2) M8-1.25 hex nuts (see Figure 25).
x 2
Figure 25. Switch installed.
12. Install rear fence rail on backside of table
using (8) M8-1.25 x 20 cap screws. Be sure
lip of fence rail faces up and away from table,
as shown in Figure 26.
Figure 26. Mounting rear fence rail.
13. Install table/dado insert in table throat (see
Figure 27). Check to make sure it is flush
and adjust if necessary (see Table/Dado
Insert Adjustment on Page 66 for more
information).
Figure 27. Table insert installed.
Model G0771 (Mfd. Since 8/15)
Lip
14. Install handwheels on shafts, making sure
notch in each wheel fits over pin on each
shaft, and secure with star knobs, as shown
in Figure 28.
Notch
Figure 28. Handwheel Installed.
15. Install saw blade as instructed in Blade
Installation on Page 29.
16. Raise motor slightly, using blade height
handwheel, and remove styrofoam block
that supports motor during shipping (see
Figure 29).
Figure 29. Location of styrofoam block to be
removed.
Star Knob
-21-