Grizzly G0771 Owner's Manual page 25

28. Check left fence scale window.
—If crosshair aligns with zero mark on left
fence scale, no adjustments need to be
made.
—If crosshair does not align with zero mark
on scale, loosen fence scale window
screws, move crosshair over zero mark,
then tighten screws.
29. Lower blade completely.
30. Using a helper, mount fence rail brace to rear
fence rail with (1) M8-1.25 x 20 cap screw
and M8-1.25 hex nut (see Figure 35).
Note: Do not tighten cap screw yet.
x 1
Figure 35. Attaching rear of fence rail brace.
31. Insert (1) M8-1.25 x 30 hex bolt into front end
of fence rail brace, then slide tab of brace
and hex head into slot in front fence rail
(see Figure 36).
Slot
Figure 36. Attaching front end of fence rail
brace.
Model G0771 (Mfd. Since 8/15)
Tab
x 1
32. Tighten cap screw and hex nut on rear end of
fence rail brace.
33. Measure distance from edge of table to rear
end of fence rail brace, then adjust front end
of fence rail brace so it is the same distance
from the table edge (see Figure 37).
Figure 37. Fence rail brace installed.
34. Secure hex bolt on front of rail brace with (1)
M8-1.25 hex nut.
35. Install end cap on right end of front fence rail
in the same manner as you did on the left end
(Step 8 on Page 20).
36. Install end caps on rear fence rail by pushing
into place.
37. Secure rear access panel with (6) pre-
installed Phillips head screws.
38. Mount dust port with (4) pre-installed Phillips
Head screws (see Figure 38).
Figure 38. Dust port installed.
x 4
-23-