Grizzly G0771 Owner's Manual page 46

5. Place workpiece against auxiliary fence and
slide resaw barrier against workpiece, as
shown in Figure 78. Now clamp resaw bar-
rier to top of table saw at both ends.
(Front View)
Workpiece
Resaw
Barrier
Figure 78. Ideal resaw workpiece setup.
6. Lower blade completely below table-top, and
slide workpiece over blade to make sure it
moves smoothly and fits between resaw bar-
rier and fence.
7. Raise blade approximately an inch, or close
to half the height of workpiece (see Figure
79), whichever is less.
Workpiece
Resaw
Barrier
/ " Connection
1
8
Figure 79. Ideal completed resaw cut.
-44-
Auxiliary
Fence
Fence
Auxiliary
Fence
Fence
The danger of kickback increases relative to
the depth of a cut. Reduce the risk of kick-
back by making multiple passes to achieve
the desired depth of cut. Failure to follow
these warnings could result in serious per-
sonal injury.
Always use push sticks or push paddles to
increase safety and control during opera-
tions which require that the blade guard
and spreader must be removed from the
saw. ALWAYS replace the blade guard after
resawing is complete.
8. Plug in table saw, turn it ON, and use a push
stick or push block to feed workpiece through
blade, using a slow and steady feed rate.
Note: We recommend making a series of
light cuts that get progressively deeper, to
reduce the chance of stalling the motor.
9. Flip workpiece end for end, keeping same
side against fence, and run workpiece through
blade.
10. Repeat Steps 7–9 until blade is close to half
the height of board to be resawn. The ideal
completed resaw cut will leave an
nection when resawing is complete as shown
in Figure 79. Leaving an
reduce risk of kickback.
11. Turn OFF table saw, then separate parts of
workpiece and hand plane remaining ridge to
remove it.
12. When finished resawing, remove resaw bar-
rier and auxiliary fence, then re-install blade
guard/spreader or riving knife and standard
table insert.
Model G0771 (Mfd. Since 8/15)
⁄ " con-
1
8
⁄ " connection will
1
8