How To Configure Dhcp Server Settings - Tenda AP5V User Manual

To set your AP's IP address in
❶
Address Type: Select DHCP.
❷
Click Save to apply your changes.
Note:
In DHCP mode, your LAN IP address is assigned by the DHCP server of your uplink device. Thus, to know your
LAN IP address, you need to check it on the DHCP client list of the uplink device.

How to Configure DHCP Server Settings

If you enable DHCP server on the device, it will automatically configure the TCP/IP settings for all your LAN
computers (including IP address, subnet mask, gateway and DNS etc.), eliminating the need of manual
intervention. Just be sure to set all computers on your LAN to be DHCP clients by selecting Obtain an IP
Address Automatically respectively on each PC. When turned on, these PCs will automatically load IP
information from the DHCP server. By default, the DHCP server on this device is disabled. The DHCP server will
be enabled while the device is operating in WISP mode. In other modes, you can also enable the DHCP server if
necessary. However, usually, it is not recommended to enable the DHCP server. Click Network > DHCP Server
to enter page below:
DHCP mode:
26