Table of Contents
Advertisement
Configure the AP
Method one: through a Tenda hardware
controller
If there is a Tenda hardware controller (a Tenda AP controller or a
Tenda router with AP management function) in the LAN, you can
manage the APs in batches through the hardware controller. For
details, please refer to the hardware controller's user guide.
Method two: through the web UI of the AP
If you do not have a controller in your network, you can configure
the AP on its web UI.
Tips
− When you need to configure multiple APs in the LAN, to avoid IP address
conflict, connect and configure one AP (including the change of IP
address) first, then repeat the steps to configure other APs.
− Record the changed IP addresses of APs for later management.
❶ Use an Ethernet cable to connect a management computer to
the AP or a switch which is connected to the AP.
❷ Set the IP address of the management computer to the same
network segment as that of the AP (default: 192.168.0.254).
For example, when the AP's IP address is 192.168.0.254, you
can set the IP address of your computer to 192.168.0.X (X
ranges from 2 to 253 and is not occupied by other devices) and
subnet mask to 255.255.255.0.
192.168.0.10
255.255.255.0
- 8 -
Advertisement
Table of Contents
