Preparation Of Remote Control; Using Of Remote Control - Teac LCDV1001 User Manual

Remote Control

Preparation of Remote Control

Follow the steps below to install the battery.
1. Pull the battery holder out from the remote control in the direction of the arrow.
2. Load a new battery properly with the (+) sided up.
3. Insert the battery holder back into the original position.
Take out battery when the remote is not in use for a long time.

Using of Remote control

Point the remote control unit from no more than about 5m from the remote control sensor and within
about 60 degrees of the front of the unit.
NOTE:
Under normal use the battery will last for six
months.
Improper use of the battery may cause
overheating, explosion or ignition, which can
result in an injury or a fire. Battery leakage
may damage the remote control.
Do not expose the remote control unit to
direct sunlight.
Do not recharge, disassemble, deform or
heat the battery.
Do not put the battery in fire or water.
Immediately replace the exhausted battery.
Take out battery when the remote is not in
use for a long time.
10