Replacing Mounting Pin On 70°, 80° And 90° Front Rigging - Invacare MyOn User Manual

10 FRONT RIGGINGS
Adjusting Calfpad Depth
1. Remove the mounting screw (A), washer (B), and locknut (C) that
secure the calfpad (D) to the calfpad bracket (E).
2. Secure the calfpad to one of four depth adjustment holes (F) using
the mounting screw, washer and locknut. Tighten securely.
3. If necessary, repeat STEPS 1-3 to adjust remaining calfpad assembly.
 Depth adjustment is only available on MyOn and
MyOn Heavy Duty.
10.5 Replacing Mounting Pin on 70°, 80° and 90° Front
Rigging
1. Remove the front rigging (A) from wheelchair (B).Refer to
Installing/Removing Front Riggings on page 49.
2. Remove mounting screw (C) that secures the mounting pin (D) to
the front rigging (A).
3. Remove mounting pin (D) from front rigging (A).
4. Install new mounting pin (D) into front rigging (A).
5. Secure new mounting pin (D) to front rigging (A) with mounting
screw (C). Securely tighten.
6. Install front rigging (A) onto wheelchair (B). Refer to
Installing/Removing Front Riggings on page 49.
Invacare® MyOn™MyOn Jr Wheelchairs
D
A,B,C
E
F
FIGURE 6
B
FIGURE 7 Replacing Mounting Pin on 70°, 80° and 90° Front Rigging
76
Adjusting Calfpad Depth
C
Part No 1167418
D
A