Invacare MyOn User Manual page 103

Installing
1. Install permanent axle (A) through the rear wheel (E), spacer (B), axle bracket (F), washer (C) and locknut (D).
2. Securely tighten with the existing locknut (D). Torque to 20-40 ft-lbs.
3. Reinstall the dust cap onto the permanent axle.
4. If necessary, repeat STEPS 1-3 for opposite rear wheel.
Quick-Release Axles
Removing
1. Hold the center of the rear wheel (A) and push in the tip of the
quick-release axle (B).
2. Pull the quick-release axle and rear wheel out of the axle bracket
(C) on the wheelchair frame (D).
3. Push in the tip of the quick-release axle again and pull the
quick-release axle out of the existing rear wheel.
4. Install new/existing rear wheel onto wheelchair. Refer to
Removing/Installing Rear Wheels on page 102.
Part No 1167418
13 REAR WHEELS/FRONT CASTERS
(B)
FIGURE 2 Removing/Installing Rear Wheels - Quick-Release
103
D
(C)
A
Axles
Invacare® MyOn™MyOn Jr Wheelchairs