Call Alert - UTStarcom CDM7026 Manual

MORE
TRAIN VOICE
Train Voice is the process of optimizing the voice recognition software to
your voice. Train Voice requires that you make recordings of your voice,
which are then used to customize the voice recognition system. This
will take a few minutes and you should be in a quiet environment for
optimum training.
1.
Press the OK Key [Menu], then press
Press "VR Settings".
2.
Press "Train Voice".
3.
Select "Train Words" or "Train Digits". You will be prompted to
speak the words listed on the screen. Say each word as you are
prompted.
4.
Press the Left Soft Key [Save] to stop train voice.
PROMPTS
The prompts settings, "Mode" or "Timeout", will allow you to set how
you are notified by the voice command system and the duration in
which you can respond. To access "Prompts:"
1.
Press the OK Key [Menu], then press
Press "VR Settings".
2.
Press "Prompts".
3.
Select "Mode" or "Timeout".
• Mode: Select "Prompt" or "Tones Only".
• Timeout: Select "5 Sec." or "10 Sec.".
4.
Press the Left Soft Key [Save] to save it.
72
for the "More" menu.
for the "More" menu.

CALL ALERT

The "Call Alert" setting controls how you are notified when receiving a
call. "Name + Ring" will first announce the name and then play the set
ring tone. "Ring only" will play the set ring tone only. "Name Repeat"
continuously states the name or number until the call is answered or
incoming call alert ends.
1.
Press the OK Key [Menu], then press
Press "VR Settings".
2.
Press "Call Alert".
3.
Select "Ring Only", "Name+Ring" or "Name Repeat".
4.
Press [Save] to save it.
MORE
for the "More" menu.
73