Power Connection - UTStarcom CDM7026 Manual

BATTERY USAGE
(BATTERY REMOVAL)
1.
Push down the release latch button, then slide the battery cover off
the phone.
2.
Lift the battery up and out of the battery cavity from the top of the
battery.
• If the battery is not correctly placed in the compartment, the handset will
Note
not turn on and/or the battery may detach during use.
12
(BATTERY CHARGING)

POWER CONNECTION

1.
Plug the AC Charger into a standard outlet.
2.
Plug the other end of the AC Charger into the charging port on
your phone. The battery must be installed onto the phone to work
properly.
• When you charge the battery with the phone power off, you will see a
Hot Key
charging status screen. You cannot operate the phone until it is powered
on.
• The battery is not charged at the time of purchase.
• Fully charge the battery before use.
• It is more efficient to charge the battery with the handset powered off.
• The battery must be connected to the phone in order to charge it.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to replace
the battery.
BATTERY USAGE
13