Cisco XR 12000 Series Getting Started Manual page 33

Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
DETAILED STEPS
Command or Action
Step 1
show version
Example:
RP/0/0/CPU0:router# show version
Step 2
admin
Example:
RP/0/0/CPU0:router# admin
Step 3
show platform [node-id]
Example:
RP/0/0/CPU0:router(admin)# show platform
Step 4
exit
Example:
RP/0/0/CPU0:router(admin)# exit
Step 5
show redundancy
Example:
RP/0/0/CPU0:router# show redundancy
Step 6
show environment
Example:
RP/0/0/CPU0:router# show environment
OL-24755-01
Purpose
Displays information about the router, including image names,
uptime, and other system information.
Places the router in administration EXEC mode.
Displays information about the status of cards and modules
installed in the router.
Some cards support a CPU module and service processor
•
(SP) module. Other cards support only a single module.
A card module is also called a node. When a node is
•
working properly, the status of the node in the State column
is IOS XR RUN. The status of the supported SPA interface
is OK.
The show platform node-id command is used to display
•
information for a specific node. Replace node-id with a
node name from the show platform command Node
column.
To view the status of all the cards and modules, the
Note
show platform command must be executed in
administration EXEC mode.
Exits the administration EXEC mode.
Displays the state of the primary (active) and standby (inactive)
RPs, including the ability of the standby to take control of the
system.
If both RPs are working correctly, one node displays active
•
role, the Partner node row displays standby role, and the
Standby node row displays Ready.
Displays information about the hardware attributes and status.
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
Verifying the System After Initial Boot
2-21