Makita 2414EN Technical Information page 9

W
iring diagram
Fig. D-2
Rib A
Space between
Rib A and Rib B
Fig. D-3
Power supply cord has to be fixed so that its
Sheath end comes to between Rib G and Boss.
Do not put Lead wires (black) of
Support unit on any Ribs in this place.
Cord clamp
Pass Lead wires (black) of Support
unit between Rib E and Rib F.
Wiring in Motor housing
Rib B
Boss
Power supply cord
Rib E
Rib F
Coil Lead wires (black) of Support unit
once into Line filter one by one. And place
Line filter in here in case it is used.
Fix Lead wires (black) of Support
unit with these Lead wire holders.
Lead wires (black) of Support unit
have to be tightened in Motor housing.
Support unit has to be put into Motor
housing so that its Lead wires (2 blacks)
can be guided out through the space
between Rib A and Rib B.
Pass Lead wires (brown, blue) of
Power supply cord and Lead wires
(2 blacks) of Support unit between
Rib C and Rib D.
Rib G
Rib C Switch
Rib D
Noise suppressor
Line filter
Noise suppressor has to be put
in the space between Switch
and Grip end in case it is used.
Do not put any Lead wires
under Switch.
P 9/ 9