Remote Controller - Panasonic CW-XC105HU Installation And Operating Instructions Manual

Remote controller

Precaution:
The Remote Controller will not function properly if strong light strikes the sensor window of the
air conditioner or if there are obstacles between the Remote Controller and the air conditioner.
OPERATION
• To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other buttons.
• When you first turn it on, the air conditioner is on
the High cool mode and the temperature is set at
72°F(22˚C).
MODE
• Every time you push this botton, it will toggle
between COOL, ECONOMY, FAN and DRY.
ON/OFF TIMER
- STOPPING OPERATION
• Every time you push this button, when the air
conditioner is operating, timer is set as follows.
(1Hour ¡ 2Hours ¡ 3Hours ¡ 4Hours ¡ 5Hours
¡ 6Hours ¡ 7Hours ¡ 8Hours ¡ 9Hours ¡
10Hours ¡ 11Hours ¡ 12Hours ¡ O).
• The Setting Temperature will be raised by
2°F (1°C) 30 min. later and by 2°F (1°C) after
another 30 min.
- STARTING OPERATION
OPERATION
1
TEMP
AIR
TIMER
SWING
3
MODE FAN SPEED
2
ECONOMY
6
• Every time you push this button, when the air
conditioner is not operating, timer is set as follows.
(1Hour ¡ 2Hours ¡ 3Hours ¡ 4Hours ¡ 5Hours
¡ 6Hours ¡ 7Hours ¡ 8Hours ¡ 9Hours ¡
10Hours ¡ 11Hours ¡ 12Hours ¡ O)
FAN SPEED
• Every time you push this button it is set as follows.
{High(F3) ¡ Low(F1) ¡ Med(F2) ¡ High(F3)...}.
TEMPERATURE SETTING
• This button can automatically control the
temperature of the room.
The temperature can be set within a range of 60°F
to 86°F by 2°F.(16˚C to 30˚C by 1˚C) Select a
lower number for a lower temperature in the room.
ECONOMY
• If you push the button, the fan stops when the
compressor stops cooling. Approximately every 3
minutes the fan will turn on and check the room air
to determine if cooling is needed.
AIR SWING
• This button can automatically control the air flow
direction.
6
5
7
4