Sartorius combics 1 Operating Instructions Manual page 34

Operating the Combics 2
Example:
Check the weight of a sample; use Tolerance Limit display mode
1032
hhx
p
ACE HARDWARE
GOETTINGEN
19.03.2002 15:43
--------------------
Setp + 100.0 g
Min + 95.0 g
Max + 105.0 g
G# + 103.2 g
T + 0.0 g
N + 103.2 g
Lim + 3.20 %
W.Diff+ 3.2 g
--------------------
34
Place a load of unknown weight on the weighing instrument
If the weight is under the lower tolerance limit, LL is shown in the tolerance limit display
(load is too light) (the weight display shows the measured weight value)
If the weight is within the tolerance range (in this example, 103.2 g),
the weight value is displayed
If the weight is over the upper tolerance limit, HH is shown in the tolerance limit display
(load is too heavy) (the weight display shows the measured weight value)
Print results
Printout
Target value
Minimum
Maximum
Gross weight
Tare weight
Net weight
Percentage of deviation from target*
Absolute difference from target
* In Tolerance Limit display mode:
If the weight is lighter than the target, the display shows: Stat
If the weight is heavier than the target, the display shows: Stat
LL
HH