Unable To Complete Adaptiq® Audio Calibration - Bose ACOUSTIMASS 300 Owner's Manual

Unable to complete
ADAPTiQ
Listen to the voice prompts for the following error messages:
Error Problem
message
1 The microphone on the
ADAPTiQ headset cannot
detect sound.
2 The room is too loud.
3 The ADAPTiQ headset is
too close to the speakers.
4 The listening locations are
too similar.
5 The ADAPTiQ headset
cannot take measurements
due to movement.
After correcting your problem, you must rerun ADAPTiQ audio calibration
(see page 12).
If you hear a different error message, contact Bose customer service for further
instructions. Refer to the contact sheet in the carton.
audio calibration
®
T R O U B L E S H O O T I N G
What to do
• Secure all cables.
• Disconnect the ADAPTiQ headset cable and
reconnect it firmly into the soundbar's ADAPTiQ
connector.
• Ensure the microphone opening on the top of
ADAPTiQ headset is not blocked.
• Your ADAPTiQ headset may be damaged. Call
Bose® customer service for replacement parts.
Refer to the contact sheet in the carton.
Rerun ADAPTiQ audio calibration when the room
is quiet.
Move the ADAPTiQ headset farther away from the
speakers.
Move 1 – 2 ft. (.3 – .6 m) away from your previous
listening location.
Hold your head still.
E N G L I S H - 2 1