Wayne Saccadic Fixator Instructions For Using Manual page 40

Now press 2 (page 3) to select elapsed Time. 2 should appear on left of display and 30 should be
on the right side of the display (for 30 seconds elapsed time). If not, enter 30 or 60 depending
upon your preferred elapsed time. A 2 should be on the left and number 30 or 60 should be on
the right. If so, press Enter.
Skip Speed 3 since this is not applicable to program 1.
Press #4 (Pattern selection). 4 should appear on the left and number 3 should appear on the
right of the display. If it does not, press 3. Now press Enter.
Press 5 for number of active lights. 5 should be on left and 1 on the right. If there is no 1 on the
right, press #1 and 1 will appear. Press Enter.
Time Out. Press 6. Display should read 6 on left and 0 on right. If it does not, press 0. Press Enter.
Flash time. Press 7. Display should read 7 on the left and 0 on the right; if not, press 0. Press
Enter. For programs that show a 7th column (after program 50) press the number shown, and
press enter.
You have now corrected the program parameters. Do not turn off the Saccadic Fixator at this
point; if you accidentally do so the program will have to be repeated.
All changes described above must be stored before turning off the unit, as follows:
How To Store Any New Or Modified Program Into Memory
After the new or modified program has been set-up and tested, depress the START/STOP button
twice; this will set the display to "0".
Depress the #8 key pad button, and enter a second number. If you are modifying an existing
program, you can enter that original program's number. If you wish to keep the original program
and want to store the new modified program, then select any number less than 169 that is not
being used by another program. This new number will be the location for your new program.
Press "enter" after you enter this second number. This will store the program into memory.
As an example, you want to store corrected program 9-1 into memory. Press green Start/Stop
button 2 times. (This is done to wipe out any previous score which may be on the display;
otherwise, the previous score will also be recorded.) Press #8 and #1 (8 tells computer you are
storing this program in memory location #l). The display should show an 8 on the left and 1 on
the right.
Press Enter. You have corrected Program 9-1 which should be permanently stored in the
memory (unless another glitch comes along).
Wayne Engineering TM , a subsidiary of Eyecarrot Innovations Corp. in Canada, is the leading provider of high-performance
instruments for testing and enhancing visual and motor skills. Learn more at www.wayneengineering.com and www.eyecarrot.com.
40