Table of Contents
Advertisement
'''If you wish to keep this modified program, it must be stored in memory. '''
How To Store Any New Or Modified Program Into Memory
After the new or modified program has been set-up and tested, depress the START/STOP button
twice; this will set the display to "0".
Depress the #8 key pad button, and enter a second number. If you are modifying an existing
program, you can enter that original program's number. If you wish to keep the original program
and want to store the new modified program, then select any number less than 169 that is not
being used by another program. This new number will be the location for your new program.
Press "enter" after you enter this second number. This will store the program into memory.
To retrieve this program you press #9 and its number, and then press "enter".
Note: The reset button was pressed twice to remove any scores on the display before placing the
program into memory. '''If you want to also store the final scores with the program, do not press
the reset button. '''
Restoring Altered Or Missing Programs
Sometimes a power glitch can cause a program to change or become unavailable. You can
correct the program by re-entering the parameters shown in the program listing, following the
instructions in Parameters and Selections. Perhaps the following will clarify the instructions:
Activity (1) Time (2) Speed (3) Pattern (4) Lights (5) Timeout (6) Flash (7) Dual (0) Ctr (0) Sound(0)
In your manual, look at program #1 and note the columns on the right hand side of the page.
These are the program parameters: Activity, Time, Speed, Patterns, Lights, and Time-Out.
Enter program #1 (press 9, 1, and Enter).
We will now check to be sure the correct parameters which were entered at the factory for
program #1 are still present and have not been adversely effected by a glitch due to any
electronic disturbance.
Press Enter. Press #1. On the left side of the display a 1 should appear. On the right side of the
display there should also be 1. Refer to chart on page 3 of your manual for the first program
listed. If number on the right is not a 1, press 1. Now you should see 1 on the right side. If an
error is made depress #0 twice and repeat entry.
Press Enter. You have selected Activity #1.
Wayne Engineering
TM
, a subsidiary of Eyecarrot Innovations Corp. in Canada, is the leading provider of high-performance
instruments for testing and enhancing visual and motor skills. Learn more at
www.wayneengineering.com
and www.eyecarrot.com.
39
Hide quick links:
Advertisement
Table of Contents
