System Configuration Used In The Manual; Procedures For Use Of Got - Mitsubishi Electric GOT 900 Operating Manual

1 FUNDAMENTAL KNOWLEDGE

1.4 System Configuration Used in the Manual

Bus connection

1.5 Procedures for Use of GOT

Install the GT Designer.
Start the GT Designer.
Carry out common setting.
Prepare the user screen data.
Connect the GOT and the personal computer with RS-232C,
and turn ON the GOT.
Install the OS and the communication driver.
Transfer the user screen data.
Connect to the PLC, and start monitoring.
(Turn OFF the GOT, then turn it ON again.)
1 - 4
A975GOT
PLC CPU (ACPU)
Describes the procedures from installation of the GT Designer to monitoring with the
GOT.
Start
Using the GOT
for the first time?
Yes
End
Data transfer
Refer to 3.1
Refer to Chapter 3 and Chapter 4
Refer to 5.1
No
Refer to 5.2
Refer to 5.3
Refer to 5.4 and 5.5
GT Works Version5
or
GT Designer Version5
Install
Personal computer
GT Works Version5/GT Designer Version5
Operating Manual (Start up Manual)
MELSOFT
1 - 4