Table of Contents
Advertisement
REMOTE DISPLAY MODE
To activate this mode, set F30 to 2. This mode is used to emulate a remote display for a separate
indicator. For it to work properly, a remote indicator must be transmitting information to the TI-500E
SS continuously and at the same transmission (baud) rate configured in A1.
Indicators can be sealed for commercial (Legal for Trade) applications as follows.
1. Power off the indicator.
2. On the back of the indicator, locate the setup/calibration switch cover.
3. Thread a wire security seal through both drilled head screws securing the calibration switch cover
as well as the single drilled head screw holding on the rear panel.
LEGAL FOR TRADE SEALING
17
Hide quick links:
Advertisement
Table of Contents
