Rinse Milk System; Descaling - Siemens TI 905 Series User Manual

For cleaning and descaling only use
■
the tablets intended for such. The
tablets were specially developed for
this appliance and new stocks can
be ordered through customer
service. ~ "Accessories"
on page 11
Never insert descaling tablets or
■
other media into the grounds
compartment.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Rinse the
milk system.
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion to
form.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
If one of the service programs is
■
interrupted, e.g. by a power outage,
proceed as follows:
The appliance automatically starts a
special rinsing.
Rinse out the water tank.
1.
Pour in fresh still water up to the
2.
"max" marking and confirm.
The programme starts and rinses the
appliance. Duration: approx.
2 minutes.
Empty, clean and re-insert the drip
3.
tray.
Empty, clean and re-insert the milk
4.
container.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
5.
programme.
Service programmes en

Rinse milk system

The milk system is automatically
cleaned with a short jet of steam directly
after preparing a milk drink.
For particularly thorough cleaning, the
milk system can be additionally rinsed
with water.
Duration: approx. 2 minutes
Press the $/± button to open the
1.
menu.
Use the rotary selector to select
2.
"Rinse milk system".
Press the rotary selector to start the
3.
programme.
Empty, clean and re-connect the milk
4.
container.
Place an empty glass under the
5.
outlet system and confirm.
The programme runs.
Empty, clean and re-connect the milk
6.
container.
Empty the glass.
7.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
8.
programme.
The milk system should also be subject
to thorough manual cleaning at regular
intervals. ~ "Cleaning the milk system"
on page 27

Descaling

Duration: approx. 21 minutes
The line at the bottom of the display
indicates in how many minutes the
water tank will need to be rinsed and
refilled with water, for example.
Press the $/± button to open the
1.
menu.
Use the rotary selector to select
2.
"Descale".
Press the rotary selector to start the
3.
programme.
29