Rinse Milk System - Siemens TI923 TI924 Series Instruction Manual

en Service programmes
For cleaning and descaling, only use
■
the tablets intended for such
purpose.They have been specially
developed for this appliance, and
new stocks can be ordered through
customer service. ~ "Accessories"
on page 11
Never insert descaling tablets or
■
other products into the grounds
compartment.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Rinse the
milk system.
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel, so cloths must
always be washed out thoroughly
before use.
Using a water filter increases the
■
intervals until a service programme
needs to be performed.
If one of the service programmes is
■
interrupted, e.g. by a power failure,
proceed as follows:
The appliance automatically starts a
special rinsing process.
Rinse out the water tank.
1.
Pour in fresh, still water up to the
2.
"max" marking and confirm.
The programme starts and rinses the
appliance.Duration: approx.
2 minutes.
Empty, clean and re-insert the drip
3.
tray.
Empty, clean and re-insert the milk
4.
container.
The programme has finished. The
appliance is ready for use again.
Press $/± button to close the
5.
programme.
28
All manuals and user guides at all-guidesbox.com

Rinse milk system

The milk system is automatically
cleaned with a short jet of steam directly
after preparing a milk drink.
For particularly thorough cleaning, the
milk system can be additionally rinsed
with water.
Duration: approx. 2 minutes
1.
2.
3.
4.
5.
The programme runs.
6.
7.
The programme has finished. The
appliance is ready for use again.
8.
The milk system should also be subject
to thorough manual cleaning at regular
intervals. ~ "Cleaning the milk system"
on page 26
Press the $/± button to open the
menu.
Use the rotary selector to select
"Rinse milk system".
Press the rotary selector to start the
programme.
Empty, clean and re-connect the milk
container.
Place an empty glass under the
outlet system and confirm.
Empty, clean and re-connect the milk
container.
Empty the glass.
Press the $/± button to exit the
programme.