Siemens TI 905 Series User Manual page 18

en Operating the appliance
The appliance is set to "barista mode"
by default. Additional values can
therefore be set using the two
navigation buttons. "Barista mode" can
also be switched off. ~ "Menu
settings" on page 22
The factory settings are shown in
orange on the display. The currently
selected settings are backlit.
Adjusting the coffee strength or
selecting ground coffee
A coffee drink is selected.
Press the " button.
1.
Use the rotary selector to set the
2.
coffee strength or select ground
coffee.
Press the "button or the rotary
3.
selector to confirm.
aromaDoubleShot function
The longer the coffee is brewed, the
more bitter substances and undesired
aromas are released. This has a
negative effect on the taste and makes
the coffee less easily digestible. For
extra strong coffee, the appliance
therefore has a special
aromaDoubleShot function. When half
the volume has been prepared, a
second portion of coffee beans is
ground and a second brew made so
that in each case only the pleasant and
beneficial flavours and aromas are
released.
The aromaDoubleShot function
Note:
can be selected for all coffee drinks
except for:
drinks with a small volume of coffee,
■
e.g. ristretto
a small volume of coffee, e.g. setting
■
a 200 ml "Caffe Latte" with a 90%
share of milk (10% share of coffee)
preparation with ground coffee
■
Dispensing two cups
■
18
Adjusting the milk/coffee mixing ratio
A coffee drink with milk is selected.
Press the milk button.
1.
Use the rotary selector to set the
2.
share of milk in %.
Example: When a value of 30% is
configured, 30% milk and 70%
coffee will be dispensed.
Press the milkbutton or the rotary
3.
selector to confirm.
Selecting cup size
A drink is selected.
Press the ml button. The preset
1.
volume depends on the type of
beverage.
Use the rotary selector to adjust the
2.
desired volume in ml increments.
Press the mlbutton or the rotary
3.
selector to confirm.
Notes
The volume cannot be changed for
■
ristretto.
The volume dispensed can fluctuate
■
depending on the quality of the milk.
Preparing two cups at once
A coffee drink or a coffee drink with milk
is selected.
Press the # button.
1.
Place two pre-heated cups on the
2.
left and right below the outlet
system.
To begin dispensing the drink, press
3.
the rotary selector.
The selected drink will be brewed and
will then be dispensed into the two
cups.
Notes
The drink is prepared in two steps
■
(two grinding operations). Please
wait until the process is fully
completed.
The aromaDoubleShot function is
■
not possible in the # selection.