General Information On 1600 Insert (Ob01601); Appliance Performance - Osburn OB01601 Owner's Manual

GENERAL INFORMATION ON 1600 INSERT (OB01601)

APPLIANCE PERFORMANCE

Fuel type
Recommended heating area
Firebox volume
[*]
Maximum burn time
(2)
Maximum heat output
Overall heat output rate (min. to max.)
Average overall efficiency
Fir
Average overall efficiency
(2)(6)
Optimum efficiency
Average particulate emissions rate
(8)
Average CO
[*]
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft, heat loss
factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the
manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a
power failure.
(1)
Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn
time and maximum heat output.
(2)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7
3
lb/ft³ and 12 lb/ft . The moisture content is between 19% and 25%.
(3)
As measured per CSA B415.1-10 stack loss method.
(4)
Higher Heating Value of the fuel.
(5)
Lower Heating Value of the fuel.
(6)
Optimum overall efficiency at a specific burn rate (LHV).
(7)
This appliance is officially tested and certified by an independent agency.
(8)
Carbon monoxide.
4
(1)
[*]
(dry cordwood)
(2)(3)
(3)
- EPA Cribs / Douglas
(3)
- Dry cordwood
(7)
Dry cordwood
2
500 to 1,800 ft (46 to 167 m
3 3
2.0 ft (0.057 m )
6 h
65,000 BTU/h (19.0 kW)
11,800 BTU/h to 42,400 BTU/h (3.5 kW to 12.4 kW)
(4)
68.0% (HHV )
(4)
To come (HHV )
80.0%
4.4 g/h (EPA / CSA B415.1-10)
To come
2
)
(5)
73.0% (LHV )
(5)
To come (LHV )
3 3
and 20 lb/ft . Other