Canon LBP3460 User Manual page 238

<D8 LAYOUT ERROR>
Cause
Remedy 1 Set [Graphics Mode] in UFR II Printer Driver to [Raster Mode], then print again.
Remedy 2 After performing a soft reset using the RESET menu, perform a hard reset to
Remedy 3 Perform "Error Skip", then continue printing. However, the data with which an
<D8 VERSION ERROR>
Cause
Remedy 1 Change the version of the UFR Printer Driver to that this printer supports, and
Remedy 2 Perform "Error Skip", then continue printing. However, the data with which an
<D8 SYNTAX ERROR>
Cause
Remedy 1 Press [Online] to continue printing from the next data. However, the page with
Remedy 2 Confirm the data to be printed, then print again.
<D8 nn ERROR> ("nn" represents two-digit alphanumeric characters)
Cause
Remedy
Downloaded from ManualsPrinter.com Manuals
The page cannot be laid out because the memory has run out.
(See Help of UFR II Printer Driver)
increase the free memory space or cycle the power of the printer, and then print
again. (Be aware that all the data in the memory that the printer has received
will be deleted.)
error has occurred is not printed properly.
Any job is sent from a UFR II Printer Driver that this printer does not support.
then print again.
error has occurred is not printed properly.
Invalid data is sent when printing using UFR II Printer Driver.
which an error has occurred and its subsequent pages are not printed.
A problem has occurred and the printer does not operate properly.
Cycle the power of the printer. If the message appears even after cycling the
power of the printer, note down the message in the display, and contact your
local authorized Canon dealer.
Message List 7-31
7