Canon LBP3460 User Manual page 233

<26 SYS.MEM.FULL>
Cause
Remedy 1 The printer continues printing by pressing [Online]. However, the data with
Remedy 2 Perform a soft reset using the RESET menu, and then increase the free space
<27 JOB START ERR>
Cause
Remedy
7
<30 MEMORY FULL>
Cause 1
Remedy
Cause 2
Remedy 1 The printer continues printing by pressing [Online]. However, the data may not
IMPORTANT
The memory construction of NVRAM is rewrote to a securable value when <30
MEMORY FULL> appears.
Remedy 2 After turning the printer OFF, restore the memory to the original condition
Remedy 3 Set EXT.RX BUFFER (See p. 5-34) in the INTERFACE MENU options in the
7-26 Message List
Downloaded from ManualsPrinter.com Manuals
Perform a hard reset or cycle the power of the printer (Be aware that all the
•
data in the memory will be deleted).
Install an optional expansion RAM module. (See Getting Started Guide)
•
The work memory required for the printer process has run out while the system
is processing the data (mainly the graphics data and text data).
which an error has occurred is not printed properly.
of RAM using the following procedure.
Perform a hard reset or cycle the power of the printer (Be aware that all the
•
data in the memory will be deleted).
Install an optional expansion RAM module. (See Getting Started Guide)
•
The specified emulation does not exist.
Press [Online] to continue printing from the next data. However, the data with
which an error has occurred is not printed.
The work memory has run out while the system is processing the data.
The printer continues printing by pressing [Online]. However, the data with
which an error has occurred may not be printed properly.
(If this error has occurred while the printer is ON) The amount of memory
specified in NVRAM could not be secured because the memory construction
had been changed (The expansion RAM is removed).
be printed properly due to the change of the memory construction.
(install the removed RAM), and then print again. (See Getting Started Guide)
SETUP menu to OFF and then print again.
<Error Skip>
<Error Skip>
<Error Skip>