THUNDER TIGER RAPTOR Assembly Manual page 13

1-5
No. Material No. Description
1 BK0093 2x46 Link Rod
2 HMC3-10B M3x10 Socket Screw
3 HMJ3-20N M3x20 Self-Tapping Screw
4 HMC3-25B M3x25 Socket Screw
5 BK0088 d3xD5x0.5 Washer
6 BK0020 Elevator Arm Shaft
7 1-5-1 Aileron Lever L Subassembly
8 1-5-1 Aileron Lever R Subassembly
Please complete subassemblies 1-5-1 through 1-5-5 first, then add them to the Main Frame. Insert the completed Elevator Control
Arm Subassembly No. 12 in between the Upper Metal Sideframes first. Then fit the plastic Pitch Control Frame Subassembly.
Next insert Items No. 6 Elevator Arm Shaft and No. 9 Elevator Parallel Lever Subassembly. Then secure the plastic Pitch Control
Frame using No. 2 Socket Screw and No. 14 Collar on the left side and then No. 14 Collar, No. 5 Washer, No. 10 Elevator Control
Lever Subassembly, No. 15 Collar and No. 4 Socket Screw for the right side. Adjust the two bolts (No. 2 and No. 4) so the
Pitch Control Frame can rock freely but without excessive play. Finally, add the two plastic Aileron Levers and the 66.5 mm
pushrod. (Refer to Page 45 for actual measurement.)
Before installing the Aileron Levers (No. 7 and No. 8), please add a small drop of Loctite on the M3x20 socket screw (No. 3) and
on the outside of the collar d3xD4x13 (No. 15). Please do the same for parts No. 2 and No. 14 and No. 4. And No. 15.
(9)
(8)
(13)
(4)
(1)
(15)
(10)
Installation of Pitch Frame
(12)
(6)
(5)
(14)
When installing the elevator control arm subassemly,
temporarily remove the two screws that hold the rear of
the upper PRG subassembly in place and move it up out
of the way.
Qty
No. Material No. Description
1
9 1-5-2 Elevator Parallel Lever Subassembly
1
10 1-5-3 Elevator Control Lever Subassembly
4
11 1-5-4 Pitch Control Frame Subassembly
1
12 1-5-5 Elevator Control Arm Subassembly
1
13 BK0086 Ball Link 4.8x20
1
14 BK0407 Collar d3xD4x4.5
1
15 BK0410 Collar d3xD4x13
1
(3)
12
BAG E
(7)
66.5mm
(3)
(15)
(2)
(14)
(11)
Qty
1
1
1
1
2
2
3
(13)
(1)