Table of Contents
Advertisement
Tracking adjustment ...
should follow the same path as they rotate.
(1) Rev up the motor until the helicopter becomes
light on its skids.
(2) When the two main rotor blades are in
track it means their blade tips should follow
the same path as they rotate, then it's ok.
(3)
When two blades are in track, the blade tips will
appear overlapped as one look at the rotor tip
path plane from the edge.
If the blades are out of track, then adjust
one of the pushrods that connects to the
main rotor blade pitch arm.
In hover, the main blades should be
around 5.5 to 6 degrees in pitch.
Flying Adjustments (1)
When the two main rotor blades are in track it means their blade tips
out of track
in track
increase
throttle gently
and not too
much
Redo steps (1) to (3) until
the blades are
properly.
44
tracking
Advertisement
Table of Contents
