Table of Contents
Advertisement
6-3
Setting up of Blade Pitch Angle
On the left side frame, there are three pitch
scales molded onto the Pitch Guide. The
three different scales are designed for
beginner, F3C and 3D pilots.
Use the "Pointer" on the collective tray and
the plastic molded scales to set up the initial
collective control.
The actual blade angle in degrees can be
checked using a pitch gauge (sol d
separately).
Note:Recommended rotorspeed at 1500 rpm for hover and 1750 rpm for idle-up aerobatics.
TT has a full line of Optional Carbon Graphite rotor blades, please contact your local dealer for ordering these
high performance blades.
6-3-1
The hovering pitch angle should be at 5.5˚-6˚. To get the
0˚ to 12˚ collective range, mount the steel linkage ball at
10.5mm away from the center of the collective servo horn.
Adjust the servo rotation at 40˚ for both up and down. This
should give you the 0˚ to 12˚.
POINTER
Collective Travel for Beginner
10.5
38
-9˚
-8˚
0˚
12˚
13˚
The optional Pitch Gauge (#3802)
-9˚
is recommended as shown.
-8˚
0˚
12˚
13˚
40˚
40˚
0˚
12˚
Advertisement
Table of Contents
