Mercury 75 Operation Maintenance Warranty Installation Manual page 81

7. Do not advance the neutral fast idle speed feature on the remote control
for starting.
8. Turn the ignition key to "START" position. Release the key when the
engine starts. If the engine fails to start in 10 seconds, return the key to
"OFF" position, wait one second and try again.
NOTE: The electronic starting system will automatically prime (choke) the
engine and increase idle speed for starting.
9. Check for a steady stream of water flowing out of the water pump
indicator hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop
the engine and check cooling water intake holes for obstruction. No
obstruction may indicate a water pump failure or blockage in the cooling
system. This condition will cause the engine to overheat. Have the outboard
checked by your dealer. Operating the engine while overheated will cause
engine damage.
GEAR SHIFTING
IMPORTANT: Never shift the outboard into gear unless the engine speed is at
idle.
Your outboard has three gear shift positions to provide operation: forward (F),
neutral (N), and reverse (R).
When shifting, always stop at neutral position and allow the engine speed to
return to idle.
Always shift the outboard into gear with a quick motion.
eng
OPERATION
19804
19805
71
27242