Mercury 75 Operation Maintenance Warranty Installation Manual page 113

Hide thumbs Also See for 75:
Table of Contents

Advertisement

4. Loosen drain screw and drain the fuel filter chamber.
5. Tighten the drain screw and attach the hose.
6. Pull the drain hose off the left side fitting. Hold the open end of the hose
over a container.
7. Loosen the drain screw and drain the float chamber.
a
8. Tighten the drain screw and attach the hose.
9. Premix the following in a container:
a. 8 cc (0.27 oz) or 2 teaspoons of Mercury Quickleen.
b. 8 cc (0.27 oz) or 2 teaspoons of Mercury Quickstor.
10. Remove the fuel filter. Refer to Maintenance ‑ Fuel System for
procedure.
11. Pour this mixture into the fuel filter opening. Install the fuel filter.
12. Prime the fuel system. Refer to Operation ‑ Starting The Engine.
13. Place the outboard in water or use the flush hose or flushing device or for
circulating cooling water. Start the engine and run at idle speed for five
minutes to allow the treated fuel to fill the fuel system.
eng
STORAGE
a
b
b
c
23752
a -
Drain screw
b -
Drain hose
c -
Right side fitting
c
23751
a -
Left side fitting
b -
Drain screw
c -
Drain hose
103

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

9080 jet115115 pro xs125 optimax

Table of Contents