Palm Tungsten Tungsten T Handhelds Handbook page 168

Chapter 16 Performing HotSync
Available only when
the Palm Desktop
software is running
Manual
If you're not sure which option to use, keep the default setting: Always
available.
If you are using a serial cradle/cable, click the Local tab to display the settings
4.
for the connection between your computer and the handheld cradle/cable, and
adjust the following options as needed.
If you are using the USB cradle/cable, you do not need to use the settings on the
Local tab for a direct HotSync operation.
Serial Port
Speed
Click the Modem tab to display the modem settings and adjust the options as
5.
needed. For more information, see
later in this chapter.
If you are attached to a network, click the Network tab to display the network
6.
settings and adjust the options as needed. For more information, see
"Conducting network HotSync operations"
Click OK.
7 .
158
® Operations
Starts HotSync Manager and monitors requests
automatically when you open Palm Desktop software.
Monitors requests only when you select HotSync Manager
from the Start menu.
Identifies the port that HotSync Manager uses to
communicate with the cradle/cable. If necessary, you can
change the port selection.
Your handheld cannot share this port with an internal
modem or other device.
Determines the speed at which data is transferred between
your handheld and Palm Desktop software. Try the As Fast
As Possible rate first, and adjust downward if you experience
problems. This setting allows your handheld to synchronize
with computer at the fastest speed possible.
"Conducting modem HotSync operations"
later in this chapter.