Recharging Problems - Palm Tungsten Tungsten T Handhelds Handbook

My phone connection drops
before I finish using it.
I get an error message when I try
to dial a phone number using
my handheld.

Recharging problems

Problem
When I place my handheld in
the cradle/cable, the indicator
light does not go on.
You need to increase the Idle timeout setting on the
Network Preferences Details screen. See
information to a network service profile"
instructions.
Make sure that the proper phone driver is installed on your
handheld. See "Updating the phone files on your
handheld" in Chapter 12
You may need to go through the pairing process on both
your handheld and your phone. See
Preferences" in Chapter 17
the pairing process on your handheld. See the
documentation included with your phone for assistance
with completing the pairing process on your phone.
Check the Phone Preferences screen and make sure the
correct phone connection is selected.
Solution
Confirm that your handheld is well seated in the cradle/
cable.
Confirm that your recharger cable is properly connected to
the back of the cradle/cable's USB or serial port connector
that plugs into your computer.
Confirm that your recharger is plugged into an AC outlet
that has power.
If you have not used your handheld for a long period, such
as an extended vacation, the battery may not contain
enough charge to power the indicator light. After your
handheld has recharged, the indicator light will function
normally.
Recharging problems
"Adding detailed
in Chapter 17
for instructions.
"Connection
for information on completing
for
261