Leveling - Maytag MDG28PNCGW Installation Instructions Manual

LEVELING

Leveling your dryer properly reduces excess noise and vibration.
1. Remove cardboard from beneath dryer. Place a level on top
edges of dryer, checking each side and front. If not level, tip
dryer and adjust feet up or down as shown in Steps 3 and 4,
repeating as necessary.
Not Level
2. Grip dryer from top and rock back and forth, making sure all
four feet are firmly on floor. Repeat, rocking dryer from side
to side. If dryer rocks, go to Step 3 and adjust leveling feet.
If all four feet are in firm contact with floor, go to Step 4.
16
LEVEL Not Level
3. If dryer is not level, remove the rubber boot if used; then use
an adjustable wrench or 25 mm (1") hex-head socket wrench
to turn legs until adjustment is completed. Check levelness of
dryer after all feet are firmly touching the ground and the level
shows dryer top to be level front to back and side to side.
HELPFUL TIP: You may want to prop up front of dryer
about 102 mm (4") with a wood block or similar object
that will support weight of dryer.
4. When dryer is level and all four feet are firmly in contact
with the floor, use a 25 mm or 1" open-end or adjustable
wrench to turn nuts on leveling feet tightly against dryer
cabinet.
HELPFUL TIP: You may want to prop dryer with wooden
block.