Adjusting The Control Cable - Toro Power Clear 621 Service Manual

Adjusting the Control Cable

Checking the Control Cable
Service Interval
After the first hour – Check the control cable and adjust it
if necessary.
Yearly – Check the control cable and adjust it if necessary.
Move the control bar back toward the handle to remove
the slack in the control cable (Fig. 009).
A. Control bar (2mm to 3mm) gap
B. 1/16" ­ 1/8"
NOTE
Ensure that a 1/16" ­ 1/8" (2mm to 3mm) gap exists
between the control bar and the handle (Fig. 009).
IMPORTANT
The control cable must contain some slack when you
disengage the control bar for the rotor blades to
stop properly.
Toro Single Stage Snow Service Manual
SPECIFICATIONS & MAINTENANCE
B A
Fig. 009
Adjusting the Control Cable
1. Slide up the spring cover and unhook the spring from
the adjuster link (Fig. 010).
B
A. Adjuster Link B. Spring Cover
C. Z­Fitting D. Unhook the Spring
NOTE
You can pull up the adjuster link and cable to make
unhooking the spring easier.
2. Move the Z­fitting to a higher or lower hole on the
adjuster link as needed to obtain the 1/16" ­ 1/8"
(2 mm to 3 mm) gap between the control bar and
the handle (Fig. 010).
NOTE
Moving the Z­fitting higher decreases the gap between the
control bar and the handle; moving it lower increases
the gap.
3. Hook the spring to the adjuster link and slide the
spring cover over the adjuster link.
4. Check the adjustment; refer to Checking the
Control Cable.
C
D
A
Fig. 010
2-15