5. Insert a screwdriver into the hole in the belt guide as
shown in Fig. 007 and flex the belt guide toward the
rotor pulley enough to pull the belt through
the gap.
A
A. Belt Guide
B. Engine Pulley
NOTE
Take care not to distort or damage the belt guide.
6. To install the new drive belt, reverse the
steps above.
IMPORTANT
Make sure to install the drive belt so that it sits above the
two tabs on the idler arm and below the idler arm brake
(Fig. 006).
7. Install the drive belt cover with the fasteners that you
removed in step 1.
Toro Single Stage Snow Service Manual
SPECIFICATIONS & MAINTENANCE
B
Fig. 007
2-11