Controls - Control Panel; Heating And Fan System; Transport And Storage - Husqvarna P 520D With cabin Operator's Manual

Controls - Control panel

1
2
3
5
1 Low beam
2 Parking lights
3 Horn
4 Turning lights
5 Hazard flashers
Low beam
The front work lighting and the low beam is connected so that
only one type of lighting is lit at a time.
If the working lights are lit and the low beam is activated the
working lights will automatically switch off. If the low beam is
deactivated the work lights will lit up again.
Turning lights
The turning lights only flashes during a short period of time.
To extend the flashing the turning lights must be reactivated.
Deactivate the turning lights manually by pressing the button
again.

Heating and fan system

The machine is equipped with a heating system that enables
the temperature in the cab to be adjusted.
Heat is adjusted with the knob on the heater hoses in the cab.
ON
OFF
The fan system is for heating in the cab and to defrost the
window.
24 –
English
OPERATING
4
Airflow can be adjusted using the knob on the top part of the
fan system.
0 - Off
1 - Minimum flow
2 - Medium flow
3 - Maximum flow
Air circulation in the cab is adjusted with the damper on the
bottom part of the fan system.
CLOSE
CLOSE
1 Recirculation damper - open
2 Recirculation damper - closed
In order to achieve optimal heat output at low temperature
(under 0°C), the fresh air intake should be blocked and the
damper kept fully open. See "Changing the fan system inlet
filter" for more information.

Transport and storage

IMPORTANT! The parking brake is not sufficient to lock the
machine during transport. Ensure you secure the machine
firmly to the transporting vehicle.
• The machine is heavy and can cause serious crush
injuries. Take extra care when loading it onto or off a
vehicle or trailer.
• Use an approved trailer to transport the machine.
• Check and observe local road traffic regulations before
transporting or driving the machine on roads.
To secure the machine on the trailer, two approved tension
belts and four wedge shaped wheel blocks should be used.
• Engage the parking brake and tie the tension belts around
the front and rear brackets.
• Secure the machine by tensioning the belts towards the
back and the front of the trailer respectively.
• Place the wheel blocks in front of and behind the rear
wheels.
1
2