Download Print this page

Assembly; Fitting The J-Handle; Assembling The Cutting Equipment; Fitting The Guard Extension - Husqvarna 535RJ Operator's Manual

Hide thumbs

Advertisement

Fitting the J-handle

Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
Slide the spacer into the slot in the loop handle.
Fit the nut, knob and screw. Do not overtighten.
Attach the J-handle to the loop handle using the three
screws, as shown.
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
WARNING! Only grass blades/grass
!
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.
12 – English

ASSEMBLY

Assembling the cutting
equipment
!
!
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted
when using the trimmer head/plastic blades and
combination guard. The guard extension shall always be
removed when using the grass blade and combination
guard.
Enter the guard extension guide in the slot of the
combination guard. Then click the guard extension into
position on the guard with the four quick-fasteners.
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.

Advertisement

loading

  Also See for Husqvarna 535RJ