Steel City 50125 User Manual page 22

ADJUSTING TABLE
POSITIVE STOPS
DO NOT attempt to set the positive stops until you have
checked and/ or adjusted both the blade tension and
blade tracking. Refer to SETTING BLADE TENSION
And BLADE TRACKING in the ADJUSTMENTS section
of this manual.
SETTING 90 DEGREE STOP
1. Loosen both table locking knobs (A). SEE FIG 17.
Fig.17
D
A
2. Let the table rest against the 90 degree stop (B).
SEE FIG.18
Fig. 18
3. Place a gage on the tabletop and up against the
saw blade. SEE FIG.19.
Fig.19
4. If an adjustment is necessary, tilt the table until it is square
to the blade and tighten the two lock knobs.
5. Loosen Hex Nut (C) and adjust the 90 degree
A positive stop (B) until it contacts the underside of the
table. Retighten Hex Nut.
6. Adjust pointer on the bevel scale (D) to read zero, if
necessary.
SETTING 45 DEGREE STOP
1. Loosen the table lock knobs (A).
2. Tilt the table until the pointer on the bevel scale
lines up at the 45 degree mark.
3. The 45 degree positive stop (E) should contact the
table at this point.
4. If an adjustment is necessary, loosen the hex nut on
the 45 degree stop and adjust stop until it contacts
the table when the bevel scale reads45 degrees.
5. Once the stop is set, retighten the hex nut.
22
SEE FIG. 19.
SEE FIG. 18.
SEE FIG. 17.
SEE FIG. 18.