Mounting The Disk Drives - Baxall MDAe Installation And Operation Manual

Installation and Operation Manual
Remove the drive support bracket. This entails removing the screws at either end of the bracket, and one screw for each
installed disk drive.
Orient the disk drive so that the IDE power connector is near the bottom of the MDAe chassis and facing the motherboard.
Populate the MDAe unit starting from the left hand side. Fasten the drive(s) in place using the supplied screws. Fasten
each drive using two screws through the bottom of the MDAe chassis, and one screw through the drive support bracket.
Remove screw
IDE Connectors
1 2
1 2 3 4
(Master) (Slave) (Master) (Slave)
Disk Drives
Remove screw(s)
1 2 3 4 5
Populate from left to right
Mounting the Disk Drive(s)
MDAe High Capacity Digital Video Storage System
3 4
5
(Master)
6 7 8
CONFIGURING THE DISK DRIVES

MOUNTING THE DISK DRIVES

DRIVE SUPPORT
BRACKET
Remove screw
Page 11