Cisco RV132W Administration Manual page 43

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
MAC Address
When the Internet Connection Type is L2TP (RV134W):
In the L2TP Settings section, enter the following information:
Auto Get IP (DHCP)
L2TP Server
Username
Password
DNS Server Source
Static DNS 1 & 2
Connect on Demand
Max Idle Time
Keep Alive
To set the MAC address of the device WAN port, do
one of the following:
To set the MAC address of the WAN port to your PC
MAC address, click Clone My PC's MAC.
To specify a different MAC address, enter it in the MAC
Address field.
Check Enable or Disable to enable or disable the
Auto get IP (DHCP) which is a method of
automatically assigning IP addresses. If disabled,
manually configure the IP address.
Enter IP address (Hint 192.168.1.10).
Enter the username.
Enter the password.
Select Get Dynamically from ISP or Use These
DNS Servers to manually configure.
Enter the IP address of the primary and or
secondary Static DNS in the fields (Hint 1.2.3.4).
Select this option if your ISP charges when you are
connected. When you select this option, the
Internet connection is on only when traffic is
present. If the connection is idle - that is, no traffic
is flowing - the connection is closed. If you click
Connect on Demand, enter the number of minutes
after which the connection shuts off in the Max Idle
Time field.
When you select this option, the Internet
connection is always on. In the Redial Period field,
enter the number of seconds after which the
device attempts to reconnect if it is disconnected.
3
41