Cisco RV132W Administration Manual page 36

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
Address Mode
Prefix Delegation
For 6rd
Mode
6rd Tunneling
In the Other Settings section, enter the following information:
NAT (Network
Address Translation)
MTU (Maximum
Transmission Unit)
Select Dynamic or Static.
If you select Dynamic, it means that if the RA (Router
Advertisement) message that the device receives, has
an M Flag "0", the device uses SLAAC (Stateless
Address Auto-configuration) to get the IPv6 address; if
the M Flag is "1", the device uses DHCPv6 to get the
IPv6 address.
If you select Static, enter the following information:
• IPv6 Address
• IPv6 Prefix Length
• Default IPv6 Gateway
• IPv6 DNS1 & DNS2
To assign a network address prefix (from ISP) to LAN,
enable Prefix Delegation.
6rd
Select Auto or Manual. If you choose Manual, enter
the following information:
• IPv6 Prefix
• IPv6 Prefix Length
• Border Relay
• IPv4 Mask Length
If enabled, all outbound traffic through this interface is
NAT'ed. If disable, all outbound traffic through this
interface is routed.
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
3
34